| 1. | Non - soldering compression fittings - compression rings - design
非焊螺旋活接头.卡套.设计 |
| 2. | Seal spring compression ring
密封弹簧压圈 |
| 3. | Second compression ring
第二道压缩环 |
| 4. | Top compression ring
第一道压缩环 |
| 5. | Die insert dimensions are finished dimensions after insert has been fit into compression ring
镶件尺寸为镶件插入压缩环后的完成尺寸。 |
| 6. | Make die 0 . d . to suit compression ring being used , by holding the standout dimension as shown
镶件尺寸为镶件插入压缩环后的完成尺寸。 |
| 7. | Die insert dimensions are finished dimensions after insert has been fit into compression ring
镶件尺寸为镶件配合装入压缩环后的最终精加工尺寸。 |
| 8. | Make die 0 . d . to suit compression ring being used , by holding the standout dimension as shown
模具外径应确保图示重要尺寸，以适应所使用的压缩环。 |
| 9. | Piston rings for general engineering ; r - rings , plain compression rings , 10 up to 1200 mm nominal diameter
一般公称用活塞环.公称直径为10至1200mm的r型环 |
| 10. | Piston rings up to 200 mm diameter for reciprocating internal combustion engines - designs , dimensions and designations for single piece rings - keystone and half keystone compression rings - specification for keystone rings
往复式内燃机直径小于等于200mm的活塞环.第7部分:单片环的设计尺寸和命名.第3节:楔表面和半楔表面压缩环.第1小节:楔表面环的规范 |
